Quiet hair dryer Factory.Introduction to common problems and maintenance methods of hair dryers

　　1. Electric hair dryer has leakage phenomenon

　　If leakage is found during use, we can first check whether the motor winding is damp (if so, dry it) and whether it is aging; Next, you can disassemble the motor and check for any damage or shell damage to the winding. If so, replace it with a new wire.

　　2. The hot air volume blown out is small

　　If the hot air volume blown out is found to be very low during use, it is likely caused by the air inlet being blocked. Therefore, the first step is to check whether the air inlet is blocked too much and handle it properly.

　　3. When the motor is running in the hot air range, the electric wire is not hot and only cold air blows out

　　If the above situation occurs, we can first check whether the electric heating wire outlet wire is detached or broken (replace with a new wire or repair welding); Whether the second switch has poor contact; Thirdly, check whether the screws that fix the electric heating wire are loose or have poor contact due to excessive oxidation; Fourth, check if the circuit is short circuited or if the heating wire is broken. If it is a short circuit, reconnect it, and if it is a short circuit, it is recommended not to repair it.

　　4. In the hot air range, the electric heating wire heats up but the motor does not rotate, and the front cylinder overheats but there is no hot air blowing out

　　If this situation occurs, whether the motor lead wire is soldered off or broken (if it is soldered off, repair welding; if it is broken, replace the wire); If it's not for this reason, then check whether the switch is blackened or severely oxidized (polished or replaced).

Read recommendations:

Ionic hair dryer maker

Hypersonic hair dryer distributors

Hypersonic hair dryer Solution

Hotel hair dryer company.Why can a hair dryer blow air

BLDC hair dryer equipment.Claims for hair dryers and suction devices